Yamaha 450 EFI aftermarket wiring harness clutch perch single mount start button. Please make sure to check with us to make sure your aftermarket wiring has the same end connector as the one pictured
Yamaha 450 EFI aftermarket wiring harness clutch perch single mount start button. Please make sure to check with us to make sure your aftermarket wiring has the same end conector as the one pictured, this one for sure fits the Raw Conections harness.This mount is a new back plate for the clutch perch and is wired for a start button. If your clutch perch has the plactic band then you need to trim it so it only fits the clutch lever, our switch mount is not desingen to have the plastic band between it and the handlebar, This is a bolt on plug and play kit that replaces the factory start button setup. Our start button mount help to save space on handlebar setups that need more spacing saving parts and put the start button in a great location that is quicker to find and the hope is that it will help get a faster dead engine start.
